DELTA DORE TTRTC TYXAL+ Manual De Instalación página 41

Glossary
TTRTC TYXAL+, is a device that uses the installa-
tion's landline.
TTGSM TYXAL+ is connected to a wireless
phone network.
PSTN:
Public Switched Telephone Network.
A PSTN telephone transmitter is connected to the
installation's landline.
GSM:
Global System for Mobile communications.
A GSM telephone transmitter is connected to a
wireless phone network.
Discreet emergency alarm:
The "Discreet emergency alarm" function can warn
the outside of any aggressor by a discreet call.
Emergency alarm with siren:
The "Emergency alarm with siren" function imme-
diately warns the neighbours by triggering both a
phone call as well as the sound of the associated
sirens.
Maintenance mode:
Maintenance mode is used to perform the activa-
tion, maintenance and diagnostic operations. The
monitoring must be off to access this mode.
The alarm control unit is switched to maintenance
mode by a keypad (touch screen or simple), a
remote control or a badge reader.
(see system guide)
Tamper alarm:
The products are protected against being opened
or dislodged.
If a burglar tries to open or dislodge one of the
products, a message is sent to the alarm control
unit which triggers its indoor siren, and the instal-
lation's sirens (indoor or outdoor siren, telephone
transmitter).
The tamper alarm is permanently activated even if
the system is off.
It can be deactivated via a CLT 8000 TYXAL+ touch
screen keypad.
To open a product, you must switch the system to
Maintenance mode.
DTMF
Dual-tone multi-frequency
SMS
Short Message Service
Partial unbundling
The calls use the France Télécom network. Internet
data and other services such as TV transit through
the ISP network.
Full unbundling
You no longer have a subscription with France
Télécom.
Data and calls transit through the ISP network.
Call cycle:
The transmitter dials the first number recorded.
If the contact does not pick up or if they do not
acknowledge the call, the transmitter then dials the
2nd number, then the 3rd... up to the 6th number.
If no contact picks up, the transmitter repeats the
cycle: no.1, no.2, no.3, etc. Hence, the transmitter
makes 16 consecutive calls or 4 cycles at the most.
Operation to perform in Maintenance mode
(see guide for CS 8000 TYXAL+ alarm
control unit § Maintenance mode)
41
EN