How Does The Transmitter Work; Presentation; Principle; Operation With A Cs 8000 Tyxal+ Alarm Control Unit - DELTA DORE TTRTC TYXAL+ Manual De Instalación

1. How does the transmitter work?

1.1 Presentation

The TTRTC TYXAL+ uses the landline of the
installation, the TTGSM TYXAL+ is connected to a
wireless phone network.
The transmitters are associated by a wireless link
with an alarm control unit or directly with detectors.
They are used to:
- remotely control the alarm (using the
transmitter's voice synthesis).
- be warned of an alert by a call to another tele-
phone, or a remote monitoring centre (according
to standard protocols: 200 Bauds FSK, ID contact,
etc. (requires a subscription)).

1.2 Principle

1.2.1 Operation with a CS 8000 TYXAL+ alarm control unit

If your installation has a CS 8000 TYXAL+ alarm control unit, the transmitter and other products of the
TYXAL+ range intrusion detectors, technical detectors, sirens, keypads
or remote controls will be associated with the CS 8000 TYXAL+ alarm control unit (50 products max.).
To control
TL 2000 TYXAL+ LB 2000 TYXAL+ CLS 8000 TYXAL+
Application
TYDOM 1000
TYDOM 1000
Volets Eclairages Chauffage
Android
1
Garage Portail Alarme
iOS
Scénarios Pièces Autres
DO TYXAL+ MDO TYXAL+ DOI PVC TYXAL+ DMB TYXAL+ DMBD TYXAL+ DMBV TYXAL+ DME TYXAL+ DMBE TYXAL+
Intrusion detectors
1.2.2 Operation in autonomous mode
The transmitter can operate autonomously.
For technical detectors (DFR TYXAL+ smoke
detector, DU TYXAL+ universal detector,
DVR TYXAL+ roller shutter detector or
DF TYXAL+ water leak detector, etc.)
are directly associated with the transmitter.
It is possible to associate a TL 2000 TYXAL+
remote control featuring the SOS function.
(press button 1 or 2 of the remote control for
2 seconds depending on the configuration).
To centralise
CLT 8000 TYXAL+ CLE 8000 TYXAL+
- remotely control your heating and 5 sets of
control system, if your installation includes
X3D products.
- create scenarios.
- know the room temperature of the installation
For an alert, the outgoing call (even if there is a
mains power failure) is used to:
- describe the alarm
- listen to what is happening on the premises
monitored and to speak simultaneously
- stop the call cycle
- stop the sirens
TTRTC TYXAL+
CS 8000 TYXAL+
DVR TYXAL+ DOS TYXAL+ DCP TYXAL+
To detect
DFR TYXAL+
45
To alert/signal
TTGSM TYXAL+ 2.0 TYXAL+ Si TYXAL+ SEF TYXAL+
To repeat
DFR TYXAL+ DU TYXAL+ DF TYXAL+
Technical detectors
To alert/signal
TTRTC TYXAL+ TTGSM TYXAL+
DU TYXAL+ DF TYXAL+
Technical detectors
EN
REP TYXAL+
DCS TYXAL+
DCS TYXAL+