Switching On The Machine; Advice On Electrical Connections; Recommendations For Use - Matfer Alphamix 2 Manual De Instruccion

• Screen displays
The screen comes on
as soon as the mixer is
8
connected to the mains
.
supply. After 4 or 5
seconds, it goes into
standby mode.
Standby mode:
Dot displayed on the
8
.
screen.
Active mode:
Zero (0) displayed on the
0
screen.
A - Stand mixer plugged in and in standby mode
(dot on the screen) .
➊
Press the button for 5 seconds to go into
active mode. A zero will appear on the screen
.
B - Switching the motor on once the mixer is in
standby mode (dot on screen
➊
Press the button.
➋
Press the button.
➌
To move up to the next speed, press the
button .
➍ To stop the motor, use the
press the button, either continuously or
repeatedly, until it goes into standby.
20
If you do not use the mixer for 2 minutes sans
➎
action l'appareil se met en veille.
C - When the mixer is already at its lowest speed
setting (1), pressing the speed reduction button
sends it into standby mode
➊ The motor stops and a dot appears on the
screen
➋ To switch the motor back on, follow the steps
in § B.
D - Every time the head is raised, the mixer goes
into standby mode
➊ The motor stops and a dot appears on the
screen
➋ To switch the motor back on, follow the steps
in § B.
E - Priority goes to stopping the motor.
➊ When the
at the same time, priority is given to stopping
the motor.
➋ The appliance goes into standby mode and a
dot appears on the screen
➌ To switch the motor back on, follow the steps
).
in § B.
F - Putting the appliance on standby.
➊
Press the
➋ To switch the motor back on, press the
button or else
button for 5 seconds, then follow the steps in
§ B.
.
.
.
or buttons are pressed
.
button for 2 seconds.
SWITCHING ON
THE MACHINE

• ADVICE ON ELECTRICAL CONNECTIONS

Before plugging in, check that your power supply
corresponds to that indicated on the machine's
identification plate.
Your appliance is supplied with a power cord fitted
with a plug designed to be inserted directly into a
standard single-phase socket:
230 V/50 Hz - 16 A.
W A R N I N G
THIS APPLIANCE MUST BE PLUGGED INTO AN
EARTHED SOCkET (RISk OF ELECTROCUTION).

• RECOMMENDATIONS FOR USE

After carrying out maintenance on the motor or the
variator, run your machine empty to check that the
drive outlet (planetary gear system) is turning in a
clockwise direction (or that the tool is turning in an
anticlockwise direction, if you are looking down at
the machine from above).