Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Air2-Aria
keypad with graphic display
•
Air2-Hedera
outdoor sounder, in white or chrome effect
•
Air2-DT200T
dual technology curtain detector, in white or brown
•
Air2-XIR200W PIR detector, 12m
•
Air2-XDT200W dual technology curtain detector
•
Air2-UT100
universal transceiver
•
Air2-ODI100W outdoor wireless dual-infrared detector
•
Air2-OTT100W outdoor wireless triple-technology detector
Each Inim control panel supports more than one Air2-BS200 module, connected
via I-BUS, in accordance with the contents of the table:
Table 2: Number of Air2-BS200 managed by the control panel
SmartLiving control panel
505
515
10
10
SmartLiving control panels with a motherboard firmware version lower than or
equal to 6.00 are unable to manage Air2-Aria and Air2-Hedera devices.
For optimal performance of the wireless system the Air2-BS200 transceiver
module must be located at the core of the wireless network and area of use of
remote-control keys, in a placement which allows easy connection of the I-BUS
cable to the control panel.
All wireless protection devices should be located high up in order to increase their
detection capabilities and prevent inadvertent masking caused by large objects or
building occupants.
It is possible to view on the keypads or via the programming and supervision
software, the strength of the Air2-BS200 wireless signal on each wireless device,
this data can be used to optimize the installation process.
A level 3 signal strength it is recommended for a good installation.
As an integral part of the system, the Air2 provides 3 inter-module transmission
channels. This feature allows you to select the channel in such way as to avoid
over-the-air interference between two close-proximity wireless systems (for
example, in two adjoining apartments).
For secure deployment and operations of the Air2 wireless intrusion protection
system, it is necessary to refer to the Installation and programming guide of the
hardwired intrusion control panel in use.
The information relating to the power-supply batteries required by Air2 devices is
shown in the Technical Specification table that follows.
The manufacturer cannot guarantee the declared battery life.
Do not use batteries other than those indicated by the manufacturer as they may
explode.
Used batteries must be disposed of in accordance with the information provided in
the leaflet inside the package.
For the technical description and installation instructions of any Air2 devices not
described in this manual, refer to the respective manuals included in the
packaging of the various devices.
Manuals may be downloaded free of charge from the web address www.inim.biz,
getting access to Extended Access and then selecting "Manuals".
For the Statement of Compliance please refer to the information provided in the
leaflet inside the package.
6
1050
10100
Prime060S
20
30
Prime control panel
Prime120L
Prime240L
20
30
Notes from the
Manufacturer
Wireless accessories
30
Note
Note
1-4
ATTENTION!
General information
Tabla de contenido
