Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation and programming manual
1.
Choose a suitable mounting placement.
2.
Using a flat-bladed screwdriver in the enclosure screw location, push open
the enclosure and separate the two parts.
3.
Hold the base to the chosen mounting placement and mark the screw holes
and tamper protection position.
4.
Pull the wires through the cable entry and wire up the Air2-BS200.
5.
Using the screws, secure the base and the tamper protection in position.
6.
Set the selection jumpers for the Bus type (position A for I-BUS or position
B for RS485).
If necessary, in the case of the RS485 BUS, set the jumper for the EOL posi-
tion (position C for EOL).
7.
Enroll the device.
8.
Re-attach the cover to the base and replace the enclosure screw.
1.
Choose a suitable mounting placement.
2.
Using a flat-bladed screwdriver in the enclosure screw location, push open
the enclosure and separate the two parts.
3.
Hold the base to the chosen mounting placement and mark the screw holes
and tamper protection position.
4.
Using the screws, secure the base and the tamper protection in position.
5.
Insert the battery, ensure you respect the proper polarity.
6.
Enroll the device.
7.
If you wish to fit the magnet, work through the steps described in the pre-
vious paragraph.
8.
Re-attach the cover to the base of the contact and replace the enclosure
screw.
1.
Choose a suitable mounting location.
2.
Open the enclosure by pushing lightly on the anchor tab and separate the
two parts.
Be careful not to remove the circuit from its housing.
3.
If you are using terminals T1 and T2, pass the cables through the cable
entry and connect them. Take care to ensure that inadmissible cable fila-
ments do not come into contact with each other or with the + clip of the
battery.
4.
Hold the base to the chosen mounting placement and mark the points for
the base attachment and tamper protection.
5.
Using the screws, secure the base and the tamper protection in position.
6.
If you wish to fit the magnet by means of the screws (included), remove the
magnet base by means of a flat-bladed screwdriver.
7.
Position the magnet base on the desired side (long or short) of the mag-
netic contact at a distance of about 2mm.
Installation
INSTALLATION
Installing the Air2-BS200
Installing the Air2-MC200
Installing the Air2-MC300
Chapter 4
4-1
A
B
C
4-2
4-3
ATTENTION!
13
Tabla de contenido
