Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Table 20: Menu bar for wireless transceivers
Key
Read
Button for reading from the control panel and writing on the control
panel the data relative the configuration of the wireless transceivers.
Clicking-on this button opens the "Wireless" window where you can
Write
This button starts the guided cloning process for the wireless keys
Clone remote-
control keys
This button starts an operation which attenuates (6db) the wireless
RF
During this period the installer can carry out tests on the stability of the
Table 21: Wireless transceiver parameters
Parameter
Section for the selection of the wireless communication channel used
Channel
Disable tamper
This option disables the tamper signal of the Air2-BS200 transceiver.
protection
This option disables the rolling code algorithm during the transmission
Disable the
Rolling Code
If an Air2-KF100 remote-control key is used on several systems, it is
The above-mentioned parameters can be accessed also from a Prime keypad:
Type-in Code (Installer PIN) , PROGRAMMING Readers , ChoosePeripheral, "reader
W"
The parameters necessary for enrolling and programming wireless terminals will
be displayed only when the terminal has been previously defined as "Wireless".
These parameters vary depending on both the type of device and wireless
terminal to be configured and the control panel to which they are connected.
18
select the transceivers from those configured.
enrolled by the transceiver of the selected reader.
The guide allows you to indicate which transceiver, from those
selectable, the cloned keys will be assigned to.
signal transmitted by the transceivers for 5 minutes.
RF connection under weak-signal conditions.
by the transceiver that simulates the reader that is undergoing
programming:
-
Channel 001, 868.1MHz
-
Channel 002, 868.3MHz
-
Channel 003, 868.5MHz
of wireless commands via the Air2-BS200 transceiver.
impractical to leave this feature enabled.
Programming wireless
Function
Function
terminals
Wireless accessories
Via keypad
5-2
Programming
Tabla de contenido
