Select And Start A Washing Programme - Electrolux ESL 47020 Manual De Instrucciones

14 electrolux
Activation/deactivation of the Multitab
function
To activate the Multitab function, press the
Multitab button. Corresponding indicator
light comes on.
To deactivate the function press the Multitab
button again. Corresponding indicator light
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the on/off button. The appliance
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A , B, and C start flashing.
3. Press function button B. The lights of
function buttons A and C go off while the

Select and start a washing programme

Important! Set the options before the start
of a washing programme. When a washing
programme operates, no options can be set.
If it is necessary to set an option, cancel the
washing programme.
Select the washing programme and de-
lay start with the door slightly opened.
The start of the programme or the count-
down of the delay start will occur only
after the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Set the desired washing programme. Re-
fer to 'Washing programmes' for details.
5. Close the appliance door, the pro-
gramme starts automatically.
light of function button B continues to
flash. The digital displayshows the cur-
rent setting.
Rinse aid dispenser deactivated
Rinse aid dispenser activated
4. To change the setting, press function
button B again, the digital display shows
the new setting.
5. To memorize the operation, switch off the
appliance.
If you decide to revert back to the
use of individual detergents we
advise that you:
1. Deactivate the multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
Setting and starting the programme with
delay start
1. Set the washing programme. Press the
delay start button until the flashing num-
ber of hours for the delay start shows in
the digital display. The delay indicator
light comes on.
2. Close the appliance door, the countdown
starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically. Delay
start indicator light goes off.