5.1
Electromagnetic Compatibility (EMC)
EVOPLUS circulators respect standard EN 61800-3, in the C2 category, for electromagnetic compatibility.
-
Electromagnetic emissions - Industrial environment (in some cases restrictive measures may be
requested).
-
Conducted emissions - Industrial environment (in some cases restrictive measures may be
requested).
6. MANAGEMENT
6.1
Storage
All the circulators must be stored in a dry covered place, with possibly constant air humidity, free from
vibrations and dust. They are supplied in their original pack in which they must remain until the time of
installation. If this is not the case, accurately close the suction and delivery mouth.
6.2
Transport
Avoid subjecting the products to needless impacts and collisions. To lift and transport the circulator use
lifting devices with the aid of the pallet supplied with it
6.3
Weight
The adhesive plate on the packaging indicates the total weight of the circulator.
7. INSTALLATION
Carefully follow the advice in this chapter to carry out correct electrical, hydraulic and mechanical installation.
Always switch off the mains power supply before working on the electrical or
mechanical part of the system. Wait for the warning lights on the control panel to go
out before opening the appliance. The capacitor of the direct current intermediate
circuit remains charged with dangerously high voltage even after the mains power
has been turned off.
Only firmly cabled mains connections are admissible. The appliance must be earthed
(IEC 536 class 1, NEC and other applicable standards).
Ensure that the voltage and frequency on the data plate of the EVOPLUS circulator
are the same as those of the power mains.
7.1
Circular Installation and Maintenance
Always install the EVOPLUS circulator with the motor shaft in a horizontal position.
Install the electronic control device in a vertical position (see Figure 1)
ENGLISH
(if contemplated).
28