Accessories; Emptying - Nilfisk GM 80CR Manual De Usuario

Photo 2
Photo 3

Accessories

The GM 80CR offers a package of standard accessories that can be connected in the
following manner. Affix the conductive plastic hose to the vacuum by inserting it into the
orifice on the lower container. Once it is inserted, rotate the inlet coupler a quarter turn to
lock it into place. Either of the straight 22 inch stainless steel wands can be fitted to the
other end of the hose by snapping it in place. You can connect the floor nozzle or the
upholstery nozzle to the end of the straight wand. The GM 80CR kit includes a
conductive crevice nozzle and conductive 3 inch round brush, which can be attached to
either the wands or to the curved steel tube at the end of the conductive plastic hose. A
tool caddy (#01720600) is also included to provide easy onboard storage of accessories.

EMPTYING:

IF THIS VACUUM CLEANER IS USED TO COLLECT HAZARDOUS MATERIAL,
DO NOT ATTEMPT TO OPEN OR EMPTY ITS CONTENTS WITHOUT PERSONAL
PROTECTIVE CLOTHING AND RESPIRATORY PROTECTION.
Photo 4
Installing the Polyliner and Paper Bag
Twist and release the two container clips located on the body of
the container, front and back. Lift off the top. Open the polyliner
and place in the bottom of the container with its walls flush
against the container sides and lipped under the container inlet
(photo 2). The excess length of polyliner is draped over the top of
the container and down the outside then rolled at the end to permit
the container clips to close.
Install a paper bag inside the polyliner according to the
illustrations printed on the paper bag itself (photo 3). Replace the
top container and fasten the two clips.
Note: Polyliners are optional. If you choose not to use a polyliner,
follow the instructions to install the paper bag.
To empty the container and its contents, first turn off the motor.
Allow the cleaner to sit undisturbed for at least thirty (30)
seconds. Then twist and release the container clips. Once the
seal is broken, turn on the motor again. This will prevent
ultrafine particles which are still suspended in the air inside the
container from escaping into the work place. Lift off the
container top. Remove the polyliner and paper bag within it
(photo 4). Then seal off the polyliner with the paper bag inside
and install a new polyliner and paper bag according to step 2,
Machine Setup.
4