Sliding Handle (Premier 170); Hose Hanger, Regulator Storage Bracket & Thermostat Storage Bracket - L.B.White Premier TS080 Manual De Instrucciones

Sliding Handle (Premier 170)

The Premier 170 is equipped with sliding handles for
convenient "wheel-barrow" style mobility.
-- Depress the snap-button on the underside of the
sliding handle storage bracket.
-- Fully extend both handles until the snap button
locks into place.
-- For storage, depress the snap button and push
the handles to fully retracted position.
FIG. 1
Hose Hanger,
Regulator Storage
Bracket & Thermostat
Storage Bracket
Assembly
1. Hose Hanger Assembly (all models)
a. Align wire hose hanger to cage nuts on back of
heater.
b. Mount the hanger using the 1/4-20 x 3/4 in.
bolts and 1/4 in. fl at washers. Tighten securely.
See Fig. 2.
2. Thermostat Storage Bracket Assembly (all
models)
a. Thread four 3/8 in. hex head screws into the
four holes at lower corner on back of heater, at
louvered door end. DO NOT TIGHTEN.
See Fig. 2, Premier 170 shown.
Premier Ductable Heaters
b. Slide the four keyholes of the thermostat
bracket mounting fl anges over the four
screws.
c. After pushing the bracket down to hold into
position, insert a 1/4 in. nut driver or standard
screwdriver through the bracket's holes
and tighten the screws securely. Store the
thermostat when not in use.
3. Regulator Storage Bracket Assembly (Premier
170) BRACKET
a. Align regulator storage bracket to the two
1/8 in. diameter holes on heater's lower case
back.
b. Mount the storage bracket to the case using
the two 3/8 in. hex head screws at this point.
Tighten securely.
FIG. 2
Owner's Manual • Premier 80-170
Bolt and Flat
Washer
Hose Hanger
Cage Nuts
3/8 in.
screws
Thermostat
Regulator
Bracket
13
Screwdriver
Storage
Bracket