Assembly - Glomex MK2+ Serie Manual Del Usuario

VENUS SATURN MARS RHINE
6.

ASSEMBLY

S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
1. First of all, make sure you have chosen a cor-
rect position to install the antenna (see section
5: "Installation").
2. Remove the antenna from the packaging box.
Remove the screws from the lower radome.
3. Underneath the base of the antenna, insert the
4 M8 threaded bars and use a liquid thread
locking product (Loctite®638).
Fig. 7
4. Use cutting template 6.1 on page 66 and use a
felt-tip pen to mark the holes for the threaded
bars and cable passage.
Fig. 8
5. Drill the 4 holes for the passage of the threaded
bars by means of an electric drill and a 8.5 mm
drill tip on the supporting surface.
Fig. 9
6. Drill the hole for cable passage by means of an
electric drill and a 28 mm hollow mill.
Fig. 10
7. Position the rubber seal so that the holes
match.
58
www.glomex.it