Troubleshooting - AquaPRO 51061-0 El Manual Del Propietario

TROUBLESHOOTING

Problem
The pump does not start or
run.
The pump operates but
delivers little or no water.
Possible Cause
1. A fuse is blown.
2. The line voltage is low.
3. The motor is defective.
4. The impeller does not turn.
1. Something is caught in the
impeller.
2. The garden hose diameter is
too small or the discharge line is
too long.
3. A check valve is installed
without a vent hole.
4.There is air lock in the pump.
5. There are coils or bends in the
hose.
6
Corrective Action
1. If blown, replace with a fuse of proper
size.
2. If voltage is under the recommended
minimum, check the size of the wiring from
the main switch on property. If OK, contact
the power company.
3. Replace the pump.
4. If the impeller does not turn, remove the
lower base plate. Locate the source of the
binding.
1. Clean out the impeller.
2.Use a larger diameter garden hose or 1
in. flexible pipe. Eliminate any excess
hose. Short hoses work best.
3. Drill a 1/16 in. - 1/8 in. (1.6-3.2 mm) dia.
hole between the pump discharge and
check valve.
4. Turn off the pump for a few seconds,
clean out the anti-airlock hole and
restart the pump.
5. Straighten the hose.