Pre-Installation - AquaPRO 51061-0 El Manual Del Propietario

18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will
reset itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the
hose is not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of
water quickly, and also check that all hose connections are tight to minimize leaks.
21. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long
time when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or
debris may cause the pump to fail. Please carefully read the manual and follow the instructions regarding
common pump problems and remedies.

PRE-INSTALLATION

APPLICATION
 This submersible utility pump is designed for water removal applications. Pump water only with this pump. It
can drain or remove water from the following: pits, sinks, window wells, basements, boats, low spot in yards,
or other flooded areas.
 This unit is not designed as a waterfall or fountain pump, or for applications involving salt water or brine! Use
with waterfalls, fountains, salt water or brine will void the warranty.
Do not use where water recirculates.

Not designed for use as a swimming pool drainer.

 Do not use this pump in water with fish present. If any oil leaks out of the motor it can kill fish.
TOOLS REQUIRED
Flathead
Screwdriv
SPECIFICATIONS
Power supply
Liquid Temp. Range
Operation Position
Operating Depth(water level)
Phillips
Screwdriver
115V, 60 HZ., 15 Amp Circuit
32 to 77°F (0- 25°C)
Vertical
Beginning min: 1 in.
Ending max: 1/8 in.
3