Removing The Attachment; Operation; Compressed Air Ratchet; Compressed Air Drill - Parkside PDMFG 180 A1 Traducción Del Manual De Instrucciones Original

♦ Then, turn the attachment using slight force until
the lock engages on the tool.

Removing the attachment

♦ To remove the respective attachment, pull the
locking ring downward.
♦ Then, twist and pull out the attachment.

Operation

Compressed air ratchet

♦ Put the required plug-in attachment onto the
square retainer .
♦ Set the correct rotational direction on the turn
bolt :
R = anticlockwise
F = clockwise
♦ Fit the plug-in attachment onto the
screw head.
NOTE
► The connection with the compressed air
source is made using a flexible compressed
air hose with a quick coupler.
You will reach the best performance of your
ratchet wrench with a compressed air hose
LW 10 mm.
│ GB │ IE
■ 32

Compressed air drill

Insert bit or drill:
♦ Open the wheel-rim chuck
.
♦ Now insert the drill as deeply as possible into
the wheel-rim chuck
♦ To clamp the drill, close the wheel-rim chuck
using the wrench
attached.

Compressed air precision drill grinder

Fitting a tool:
CAUTION!
► The shaft diameter of the tool must exactly
match the clamp bore of the collet chuck
(Ø 6.35 mm)!
♦ Insert the tool in the collet chuck
♦ Hold the spindle
♦ Tighten the collet chuck nut
bly tool .
■ Ensure the accessory tool is firmly attached.
CAUTION!
► If no tool is inserted in the collet chuck
do not tighten the collet chuck nut
assembly tool , screw it on by hand only!
Switching on and off
Switching on:
♦ First, press the trigger lock
trigger forwards to switch the tool on.
Switching off:
♦ Release the trigger
♦ When you have finished working, disconnect
the tool from the compressed air source.
using the wrench
.
. Ensure the drill is firmly
.
using the assembly tool
using the assem-
with the
and then the
.
PDMFG 180 A1
.
,