Loading The Lava Stone; Grease Collection Tray; Igniting And Extinguishing The Burners; Pilot Ignition - ALI 90GL/G400 Instrucciones Para Instalación, Uso Y Mantenimiento

•
The grill must not be used to heat pans or saucepans.

LOADING THE LAVA STONE

The appliances come complete with:
packs of
400
lava stone
3 x 4kg
The lava stones have a min. diameter of 25mm, a max.
diameter of 30mm and a max. length of 50mm, with a +/- 5%
tolerance.
The second pack must only be used to top up the lava stone
originally loaded as the latter is gradually consumed.
Distribute the contents of one pack evenly between the
braziers.
Do not under any circumstances use more lava stone than
recommended.

GREASE COLLECTION TRAY

Any grease from cooking which drips into the grill and passes
through the brazier is collected in the grease collection tray.
Periodically empty and clean this tray.

IGNITING AND EXTINGUISHING THE BURNERS

The gas tap control knob has the following positions:
Off

Pilot ignition

Minimum flame
Maximum flame
PILOT IGNITION
•
Press and turn the knob to position
• Press the knob down fully and light the pilot using the
piezoelectric igniter.
•
Hold the knob down for about 15-20 seconds before
releasing it.
•
If the pilot flame goes out, repeat the operation.

MAIN BURNER IGNITION

•
Turn the knob from position
•
Next, depending on cooking requirements, turn the knob to
any position between

SWITCHING OFF

•
To switch the main burner off, turn the knob to position
•
To switch off the pilot flame, press and turn the knob to
position .

12 PROLONGED DISUSE

Before any prolonged disuse of the appliance, proceed as
follows:
•
Clean the appliance thoroughly.
•
Rub stainless steel surfaces with a cloth soaked in
Vaseline oil to create a protective film.
•
Shut off taps and main switches up line of appliances.
Following prolonged disuse, proceed as follows:
•
Inspect the appliance thoroughly before using it again.
•
Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
32
S900 S700
800 400
6 x 4kg 2 x 4kg
.
to position .
and .

REMINDERS FOR CLEANING

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
800
•
Disconnect the appliance electric supply, if present, before
4 x 4kg
carrying out any operation.
•
Clean the satin finish stainless steel exterior surfaces, the
cooking wells and the surface of the hotplates every day.
•
At least twice a year, have an authorized technician clean
the internal parts of the appliance.
•
Do not use direct or high pressure water jets to clean the
•
appliance.
•
Do not use corrosive products to clean the floor beneath
the appliance.
SATIN FINISH STAINLESS STEEL SURFACES
•
Clean the surfaces with a cloth or sponge using water and
proprietary non-abrasive detergents. Follow the direction of
the satin finish lines. Rinse repeatedly and dry thoroughly.
•
Do not use pan scourers or other iron items.
•
Do not use chemical products containing chlorine.
•
Do not use sharp objects which might scratch and damage
the surfaces.

COLLECTION TRAYS

Clean the surface, removing grease, oil, food residue etc...
CLEAN THE INTERNAL PARTS OF THE GAS LAVA
STONE GRILL
• Lift up and remove the cooking grille and the brazier
containing the lava stone.
• Proceed to clean the burner around the flame zone and
along the flame protector apertures using a wire brush to
eliminate all traces of dust, burnt-on residue and refractory
material used in the brazier, whilst taking care not to
enlarge the flame apertures.

INSTRUCTIONS FOR MAINTENANCE

REMINDERS FOR THE MAINTENANCE TECHNICIAN

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
•
Read this
information for safe installation, use and maintenance of
.
the appliance.
•
Installation, conversion to a different type of gas and
appliance maintenance must be carried out by qualified
technicians authorized by the manufacturer, in compliance
with current safety standards and the instructions in this
manual.
•
Identify the specific appliance model. The model number is
detailed on the packing and on the appliance data plate.
•
The appliance must be installed in a well-ventilated room.
•
Do not obstruct any air vents or drains present on the
appliance.
•
Do not tamper with appliance components.
13 CONVERSION TO A DIFFERENT TYPE OF GAS
See Chapter "Instructions for installation".

INSTRUCTIONS FOR CLEANING

manual carefully. It provides important