Turning On The Cooking Zones And Adjusting The Power - De Dietrich DTG1138X Manual De Instalación Y Utilizacion

EN 3 /USING YOUR APPLIANCE
• TURNING ON THE COOKING ZONES
AND ADJUSTING THE POWER
— Select the burner that you wish to use by
placing your finger squarely on the
corresponding touch control
➡ The selected power display shows a
flashing .
— Choose the heating power by pressing on
the touch controls:
➡ sets power level
➡ sets power level
➡ Sets power level
➡ Sets power level
The hob turns on automatically. You can ad-
just the power of the cooking zone by press-
ing the touch controls
— Locking: press the control
will hear a beep. Hold you finger down for
about 3 seconds: you will hear 2 beeps and
the indicator lights up.
The controls are locked, except for the on/off
control and the overall off touch control.
— Unlocking: press and hold for about
3 seconds the touch control
The indicator goes out. The hob returns to
all the confirmed settings.
— Overall off: You can turn off any operating
gas burners immediately by pressing the
overall off touch control
lock if this was in operation.
•
Residual heat indicator
After intensive use, the cooking area may
remain hot for a few minutes.
An " H" is displayed to warn users. Do not
H"
touch the zones concerned during this time.
(fig. 01) .
(max) (Fig. 02) .
(min) (Fig. 03) .
(Fig. 04) .
(Fig. 05) .
or .
(Fig. 06) : you
(Fig. 06) .
. This cancels the
Fig. 01
Fig. 02
Fig. 03
Fig. 04
Fig. 05
Fig. 06
Tip
- The flames of the gas burner are
smaller near the support to protect the
enamel.
Note
- If the flames go out accidentally (e.g.
due to a gust of air), your hob is equipped
with an automatic relighting system. This is
limited to 2 re-lightings separated by
10 seconds.
- The minimum ambient temperature for use
is 10°C to ensure optimal functionning of the
tap.
56