Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WLL* (t)
Standard lifting height** (m)
Minimum distance between hook H (mm)
Maximum force on handle at WLL* (N)
Number of strands
Chain dimensions (type T)
Dimensions (mm)
Net weight (kg)
Additional weight by lifting m (kg)
*: Working Load Limit.
**: other travel distances possible for 0.5 t. to 6 t. models:
Optionally, the bravo™ hoists with WLL of 0.5 t. / 0.75 t. / 1 t. / 1.5 t. / 3 t. and 6 t. can be equipped with a dynamic
load limiter adjusted between 1.2 and 1.4 x WLL. The load limiter mechanism is integrated in the lever and is
formed by friction disks and a clamping nut by which the limiter is adjusted. This adjustment is performed by
TRACTEL
®
.
3. INSTALLATION
Before installing the bravo™ hoist make the
following checks:
1. Check that the hoist is in good condition.
2. Check that the correct hoist capacity is to
be used.
3. Check that the hooks and safety latches are
in good condition.
4. Check that the low limit stop is in place.
5. When the hoist uses a multiple strand
chain, make sure that the strands are not
tangled or twisted.
6. Check that the load chain is correctly fitted.
7. Check that the anchor point is sufficient to
take the intended load.
After successfully completing the preliminary
checks, install the bravo™ hoist on its
anchoring point and perform the following
checks:
1. Check that the bravo™ hoist is properly
suspended by its suspension hook (item 5,
fig. 1) and that the hook safety catch (item 6,
fig. 1) is properly closed (see figs 2 and 3).
0.25
233
260
4 x 12 5 x 15
A
91
B
70
C
71
D
157
E
21
Ø
28
2
0.34
0.25 t. model:
2. Check that the load chain has not become
3. Without load, check that the up and down
4. When using the hoist with a push
After successfully completing these checks,
place the load in position and ensure:
1. the anchoring accessory of the load sits
2. the load on the hoist is free to align itself
5
0.5
0.75
1
1.5
305
310
320
340
250
330
1
6 x 18
110
147
147
80
87
87
122
126
126
228
268
268
23
26
27
35
37
40
5
7
7.3
0.54
0.8
0.8
3 m; 4.5 m; 6 m
6 m
twisted during installation.
functions operate correctly.
suspension trolley, without load, check that
the trolley moves freely. If using a geared
suspension trolley, without load, check the
direction of movement by pulling on the
trolley hand chain. The movement should
be carried out on a strictly horizontal plane.
fully in the hook and does not prevent the
catch from closing correctly (see figs. 2
and 3).
with the machine's anchoring point.
1.5
3
6
360
485
620
420
420
450
2
7 x 21
10 x 30
178
203
203
105
110
110
146
193
235
368
348
348
31
40
45
45
55
65
11.3
21
29.8
1.09
2.23
4.46
GB
Tabla de contenido
