Cutting Equipment - Husqvarna 129RJ Manual De Instrucciones

WARNING: Engine exhaust fumes
contain carbon monoxide, which can
cause carbon monoxide poisoning. Do
not start or run the machine indoors, or
anywhere that is poorly ventilated.
WARNING: The exhaust fumes from the
engine are hot and may contain sparks
which can start a fire. Never start the
machine indoors or near combustible
material.
Locking nut
A locking nut is used to secure some types of
cutting attachment.
When fitting, tighten the nut in the opposite
direction to the direction of rotation of the cutting
attachment. To remove it, undo the nut in the
same direction as the cutting attachment rotates.
(The nut has a left-hand thread.) Tighten the nut
using the socket wrench.
The nylon lining inside the locking nut must not be
so worn that you can turn it by hand. The lining
should offer a resistance of at least 1.5 Nm (1,1 ft
lb). The nut should be replaced after it has been
put on approximately 10 times.

Cutting equipment

This section describes how to choose and
maintain your cutting equipment in order to:
Reduce the risk of blade thrust.
•
Obtain maximum cutting performance.
•
Extend the life of cutting equipment.
•
IMPORTANT:
Only use cutting attachments with the guards
•
we recommend. See the "TECHNICAL DATA"
section.
Refer to the instructions for the cutting
•
attachment to check the correct way to load
the trimmer line and the correct line diameter.
Keep the teeth of the blade correctly
•
sharpened. Follow our recommendations. Also
GENERAL SAFETY PRECAUTIONS
refer to the instructions on the blade
packaging.
Maintain the correct blade setting. Follow our
•
instructions and use the recommended file
gauge.
WARNING: Stop the engine before doing
any work on the cutting attachment.
Ensure the cutting attachment has
stopped rotating completely. Disconnect
the lead from the spark plug.
WARNING: Using an incorrect cutting
attachment or an incorrectly sharpened
blade increases the risk of kickback.
Cutting equipment
Grass blades and grass cutters are intended for
cutting coarse grass.
A trimmer head is intended for trimming grass.
General rules
Only use cutting attachments with the guards we
recommend. See the "TECHNICAL DATA"
section.
Keep the teeth of the blade correctly sharpened.
Follow our instructions and use the recommended
file gauge. An incorrectly sharpened or damaged
blade increases the risk of accidents.
Check the cutting attachment for damage or
cracks. A damaged cutting attachment should
always be replaced.