Final Test - Olympus PT-E02 Manual De Instrucciones

Final Test

The final test after loading the camera is explained below. This is the only way to eliminate
worry about possible entry of water! Always perform this test. It can be performed easily in a
water tank or a bathtub. The required time is about five minutes.
Simple water immersion
test
Place the Case slowly
1
into the water.
At first, immerse the
2
Case for only three
seconds.
Check that no water has
3
entered into the Case.
Next, immerse the Case
4
for 30 seconds.
Check that no water has
5
entered.
En
Next, check by
6
immersing for three
minutes.
This is the final check.
7
Has the silica gel
become moist?
If there is no water
leakage and everything
8
is functioning correctly,
you are ready to start
shooting underwater.
❈ The case shown in the above photos is for compact cameras. However, this Case can
also be tested with the same method.
Explanatory image
As the Case is transparent,
waterdrops entering into it can be
confirmed easily.
In case of trouble with the O-ring,
three seconds are enough for water
to enter. Are there air bubbles coming
out between the lids?
Please check carefully.
Remove the Case from the water and
check that no water has accumulated
at the bottom of the Case.
Is there any water trickling down?
Check carefully for air bubbles!
Do not perform any operation yet,
but just observe.
Remove the Case from the water and
check that no water has accumulated
at the bottom of the Case.
Perform very careful confirmation.
Check carefully for air bubbles! Try operation of the buttons used frequently.
Check carefully for air bubbles!
If there is still no entry of water, everything
is OK!
This is very important!
Has the silica gel become moist?
Please check carefully!
As the inside can be seen, the inspection for
entry of water also can be made securely!
Now everything is all right!
Have a nice dive!
Did you remember to attach the
balance weight?
E-25
Hints