UNPREDICTABLES – SOLUTION OF PROBLEMS
Upon coming across any problem in operation, follow the instructions below to check
and repair the problem, and/or get in touch with your representative.
Imprevistos
- Micromotor retrogresses
continuously.
- Reduced battery capacity.
EQUIPMENT'S WARRANTY
This equipment is covered by the warranty terms and norms contained in the Warranty
Certificate that accompany the product.
FINAL CONSIDERATIONS
Among the care you have to take with your equipment, the most important is regarding of
the spare parts replacement.
To ensure the lifetime of your device, only replace original spare parts from Gnatus. They have
the assurance of the standards and technical specifications required by the Gnatus representative.
We call your attention to our authorized resellers' chain. Only this chain will keep your
equipment constantly new, because it has trained technical assistant and specific tools for the
correct maintenance of your device.
Whenever you need, demand the presence of a Gnatus' technician from the nearest resale,
or ask through the Attendance Service GNATUS: + 55 (16) 2102-5000 / SAC: 0800-7015-054.
Provável Causa
- Very high canal resistance.
- Canal in bad condition
(M3, M4 e M5).
- The pre-determined apex
position is very high(M3, M4
e M5).
- The canal opening is very
small (M3, M4 e M5).
- The file is too big (M3, M4
e M5).
- Electromagnetic Interfe-
rence.
- It hasn't been charged
completely.
- The battery is not holding
the charge.
68
Soluções
- Raise the torque manually
in advance/reverse mode.
- Clean the liquid and re-
sidue, change to the mode
without the (M1).
- Reprogram the apex po-
sition.
- Enlarge the canal.
- Replace for a smaller one.
- Do not use the charger to
Charge.
- Charge the battery for at
least 4 hours.
- Enter in contact with Gna-
tus technical assistance.