Preparation Before Use - GNATUS ENDUS DUO Manual Del Propietário

EQUIPMENT OPERATION

Preparation before use

After the equipment is correctly installed, press the POWER key to turn on the equipment,
2 beeps will sound.
Press the MODE key to select the operational mode and PROGRAM to choose one of
the 9 pre-defined programmings, which will be saved for the other modes.
To adjust the values, choose the M1 mode.
The torque value and the program number will blink one after the other, press the SET
to select the next option and at this moment, press the "ADJUST+" key or the "ADJUST-"
key to choose the desired value. Three (3) seconds after the last key has been pressed, the
numeric value will be saved. Then, press the SET key again to confirm the numeric value
to be saved or to edit a new value.
By pressing the REVERSE key, the micromotor retrogresses, spinning counterclockwise.
The programmings can only be made on mode M1 (without the apex
locator function).
The programmings will be saved for all the modes even after the
equipment has been turned off.
Apex locator (M2 mode)
Press the SET key on mode M2, the apex mode will blink with the last
p o s i t i o n c o n f i g u r e d . A d j u s t t h e a p e x p o s i t i o n o n a 0 , 0 t o 1 , 0 m m
range by pressing the "ADJUST+" and "ADJUST-" buttons. Three (3) seconds
after the last touch the apex mode will stop to blink and the configuration will be finished.
The apex position can only be adjusted on Mode M2 (Apex locator
mode).
57