Performing Care And Control Work; Dismantling And Cleaning Of The Chuck - Schick Dental QUBE II Manual De Instrucciones

Performing care and control work

Dismantling and cleaning of the chuck

1.
9490
3.
9142
(2.35 mm)
9140
(3.00 mm)
1. Remove the tools, unscrew the tip and remove the dust cap from the handpiece
2. Insert the chuck key (Art.No. 4115) into the open chuck, hold in place on the wrench
grip surface of the shaft with the open-ended spanner (Art.No. 9188) and pull out the
chuck with a sudden movement or by knocking on the chuck key, if
3. Remove the chuck from the shaft
After thoroughly cleaning the chuck, slightly grease it on the outside with special
grease (Art.No. 51/1) before re-installation.
Tighten the chuck only slightly when re-installing! In normal operation (right-hand
rotation), the chuck tightens itself.
In order to preserve the chuck's accuracy and service life, a tool or the protective
pin provided from factory must always be clamped - even when the unit is not be-
ing operated.
Never clean the handpiece with compressed air!
The corresponding chuck tools can be found on the underside of the handpiece
rack.
D21518 Original
Care and control tasks for operators 10
2.
4115
Instructions
9188
necessary.
27/32