Function Description; Interfaces; Characteristics Of The Tools - Schick Dental QUBE II Manual De Instrucciones

Function description

The handpiece is used as a hand-held grinding or separating tool. The handpiece speed is
limited through the operating unit and its touch-sensitive surface. Depending on the ver-
sion, the speed is variably controlled via the knee plate, foot lever or the connected dy-
namic foot pedal (table control unit only).

Interfaces

The control units of the
Connection for controlling extraction systems. The pulse emitter for the extraction signal
must be connected in order to operate the in
workstation extraction system. This is plugged into the pulse transmitter for suction of the
control unit as shown in the figure, and on the other end into the corresponding socket of
the workplace extraction system. If the
Single Workstation Extraction unit or a Zubler AP 501 Extraction Point Opener, the op-
tional control line Article no. 9229 can be used for connection and to establish the
switching signal.

Characteristics of the tools

Only tools with perfect concentricity may be used. The shaft diameter may be 2.35 mm or
3 mm, depending on the chuck variant.
D21518 Original
feature the following interfaces to other machines:
is operated with a KaVo SMARTair
Instructions
Technical description 4
conjunction with an automatic
13/32