How To Install The Appliance - Ferroli FCM 400 Manual De Instalación

HOW TO INSTALL THE APPLIANCE

· Mark the position of each support, the connecting pipes and
discharge of the condensate, of the electrical cables and po-
wer commands (see dimensions) . The cardboard template
can be supplied with help in this operation (Fig .4) .
· Hang up the bearing brackets supplied with the appliance.
Take care to keep them a certain distance (h) (Fig .6) from the
false ceiling (See attached table) . Do not tighten the nut or
check nut. This will only be done after the unit is levelled, at
the end of the installation phase .
Note: Depending on the type of ceiling, choose the most ap-
propriate tie rods (Fig . 6A) .
Remember the total weight for the different units .
MOD . Weight [kg]
400
400-4T
600
750-4T
850
1500
Lift the unit (without the frame) carefully by gripping it on the
four corners .
Match the side slots (1 Fig. 7) to the four brackets (2 Fig. 7).
Insert the brackets into the slots and screw the safety screws
(Fig .8) .
· Level the appliance with a level and allow 10-12 mm betwe-
en the sheet metal casing and the lower surface of the false
ceiling (Fig .9) .
· Connect the condensation drain pipes and make the wet
connections, then check to make sure that the appliance is
still level .
h [mm]
19 49
19 .2 49
29 140
33 .5 140
33 140
35 140
INSTALLATION
2
10-12 mm
Fig . 4
Fig . 5
Fig . 6
Fig . 7
1
Fig . 8
Fig . 9
13