Ordering Replacement Parts - EINHELL KGS 250 Manual De Instrucciones

G.) Mitre cuts 0°-45° and rotary table 0°-47°
(Fig. 10)
The KGS 250 can be used to make mitre cuts on the
left at an angle of 0°-45° relative to the work top and
0°-45° relative to the stop rail.
Lift the machine head (4) to its top position.
Undo the rotary table (8) by slackening the
locking handle (10) and pressing the latch (11).
Adjust the rotary table (8) by its handle (2) to the
required angle (see also Section D).
Re-tighten the locking handle (10) to fix the rotary
table in position.
Undo the clamping nut (12) and, holding the
handle (2), tilt the machine head (4) to the left to
the required angle dimension
(see also Section E).
Re-tighten the clamping nut (12).
H.) Chip extractor (Fig. 2)
The saw is equipped with a bag (14) to collect
sawdust and chips. You can pull off the sawdust bag
(14) to the rear by pressing together the two clips
(27). To empty the bag, undo the zip at the bottom.
I.) Replacing the saw blade (Fig. 10)
Pull out the power plug.
Swing up the machine head (4).
Undo the cheese-head screw (29) and flip back
the connecting part (35).
Slacken the two recessed head screws (28) and
take off the hinged saw blade guard (6).
Unscrew the 4 recessed head screws (23) and
take off the left saw blade cover (15).
Use the supplied face wrench (30) to lock the
outer flange (33) in place and use the socket
wrench (31) to unscrew the hex screw (Important:
left-hand thread. Unscrew clockwise!).
Take the saw blade (5) off the inner flange and lift
up and out.
Mount the new saw blade in reverse order and
fasten.
Important! The cutting bevel of the teeth, i.e. the
direction of rotation of the saw blade, has to
conform with the direction of the arrow marked on
the housing.
Clean the saw blade flanges thoroughly before
mounting the saw blade.
Re-fit the hinged saw blade guard (6) in reverse
order.
Before using the saw again, check that the safety
devices are in good working order.
8. Maintenance
Keep the machine's air vents unclogged and
clean at all times.
Remove dust and dirt regularly from the mac
Cleaning is best done with compressed air o
rag.
Re-lubricate all moving parts in regular interv
Never use caustic agents to clean plastic pa

9. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part require
G