Technical Data - EINHELL RT 300 Manual De Instrucciones

Anleitung RT300/500
GB
Plug connectors must be equipped with earthing
contacts and the coupling must be rain-water-
protected.
Keep cables and other objects out of the area
you want to cut.
If you have to lift the trimmer to move it, switch off
the motor and wait for the rotating tool to stop.
Before you leave the trimmer, switch off the
motor and pull out the power plug.
Before you connect the trimmer to the power
supply, make sure that none of its moving parts
are damaged and that the line reel is correctly
inserted and fastened.
Never cut against hard objects when using the
trimmer. This is imperative to avoid causing injury
to the user and damage to the trimmer.
Use only original replacement parts for repair and
maintenance purposes.
Have repairs carried out only by a qualified
electrician.
Caution! The nylon line will run on for a few
seconds after the tool is switched off!

2. Technical data

Voltage
Power rating
Cutting width
Speed
Nylon cutting line
Sound pressure level LPA
Sound power level
Vibration aw
Weight
Art. No.
10
31.10.2001 10:59 Uhr
RT 300
230V ~ 50 Hz
300 W
Ø 25 cm
10.800 rpm
Ø 1.2 mm
81 dB(A)
92 dB(A)
1.2 m/s2
2,2 kg
34.012.31
Seite 10
2. Technical data
Voltage
Power rating
Cutting width
Speed
Nylon cutting line
Sound pressure level LPA
Sound power level
Vibration aw
Weight
Art. No.
The noise level of this machine may exceed 85
dB(A). In this case, noise protection measures need
to be introduced for the user. The machine's noise
was measured in accordance with IEC 59 CO 11,
IEC 704, DIN 45635 Part 21, NFS 31-031
(84/538/EEC).
The level of vibrations emitted from the handle is 1.2
m/s. Measurements were taken in accordance with
ISO 5349.
3. Assembling the guard hood and the
handle
Plug the guard hood on the housing and fasten
with the 4 screws supplied (Figure A).
Fit the handle as shown in Figure B and C.
4. Replacing the nylon line reel
Caution! Be sure to unplug the grass trimmer
before you replace the nylon line reel!
Holding the reel holder (Figure D / 8) in the one
hand, use the other hand to depress the grooves on
the side of the reel cover (Figure D / 9) and unscrew
the reel cover as indicated by the arrow on the reel
cover itself. After you have taken off the reel cover,
remove the empty line reel, taking care not to lose
the setting button and the spring. Insert the button
and spring in the reel holder. Take the new line reel,
push the ends of the lines through the holes in the
reel cover, and refit the reel cover (Figure E).
RT 500
230V ~ 50 Hz
500 W
Ø 30 cm
10.800 rpm
Ø 1.2 mm
81 dB(A)
92 dB(A)
1.2 m/s 2
2,4 kg
34.015.00