Installation; Transportation; Lifting And Handling; Positioning - ifi SAM80 Manual Para El Uso Y Mantenimiento

2 INSTALLATION

2.1 TRANSPORTATION

The display unit is usually shipped using overland transport.
request.

2.2 LIFTING AND HANDLING

The display unit should be lifted out of the transporting
ATTENTION!
The lifting platform fork must be at least
1 m / 3.2 ft long.
Position the display unit correctly by
placing its centre of gravity in the middle
of the support area on the lifting vehicle
forks.
Once the equipment is on the ground, we recommend the packaging is removed immediately in order to
check the item is intact and has not been damaged during transportation. The following should be checked
in particular:
- The supporting elements for the glass surfaces.
- To opening mechanism of the front glass panel.
- The adherence of the seal cushioning the front glass panel.
NOTE:
may the damaged display unit be returned to the manufacturer without prior notice or written
authorisation.

2.3 POSITIONING

Before installing the equipment, please take into account the following considerations:
- Leave a space of at least 50 cm (1.6 ft) between the unit and any other item, on both the operator side
and the customer side, so that air can circulate in the motor compartment.
- Calculate the space required to operate the unit and perform maintenance in safe conditions.
- Remove all packaging protecting the display unit.
for the power supply cable.
Place the display unit in the chosen position, remembering to remove the two strips at the base of the unit
The display unit should be positioned in such a way that it is perfectly level.

2.4 ENVIRONMENTAL SPECIFICATIONS

ATTENTION!
The display unit can operate at a maximum room temperature of 35°C and at 60% relative
humidity (30°C/55% for refrigerated console version).
Fig.4
44