Kenmore 911.45241 Guía Para El Uso Y Cuidado página 14

CARE ANDCLEANING
RemovableParts (cont.)
1. Grasp the edge of the cooktop and
lift up.
2. Holding the cooktop with one
hand, lift the support rod up and
rest the edge of the cooktop on it.
3. When cleaning is finished, lower
the support rod and the cooktop.
_ CAUTION: When
working in this area, be
careful not to bump into
the support rod. The porcelain
enamel surface of the cooktop
can chip if dropped.
k,_ ............ -,_
Element __
Drip Bowls Receptacle
TO REMOVE
1. Be sure the controls are in the off
position and the elements are cool
before attempting to remove them.
2. Grasp the element and lift slightly,
just enough to clear the drip bowl
and pull it straight out.
3. Lift out the drip bowl
_ AUTION: Do not lift
the element more than I".
Lifting the element
more than 1" can damage the
receptacle, causing the element
not to lie flat when it is plugged
back in.
TO CLEAN THE DRIP BOWL
For brown food stains - use
dishwashing detergent, warm water,
plastic scouring pads, mild abrasive
cleaners, soap-filled scouring pads or
ammonia. Clean drip bowls after each
use Rinse and dry well. Foods that
are not removed can cause
permanent stains that cannot be
removed, For heavily soiled bowls,
place an ammonia-soaked paper
towel over the bowl to loosen the soil,
then gently scrub the bow! with a
plastic scouring pad.
For blue-gold heat stains - use a
metal polish, These stains are caused
by overheating, and are usually
permanent. To help minimize this
effect, avoid excessive use of high
heat settings and use flat bottom
pans that do not extend more than 1"
from the edge of the cooking element.
p._ .................... •
_ AUTION: Do not
operate the cooktop
elements without the drip
bowl in place. Scorching of the
cooktop, burning of wiring
insulation and loss of energy
will occur.
TO REPLACE THE UNIT
1. Place the drip bowl into the
opening and make sure the
receptacle is visible.
2. Slide the element firmly back into
the receptacle and lower it onto the
drip bowl
14