Installation Preparation; Preparing The Installation Cavity - Bosch B36ET71SNS Instrucciones De Instalación

4.

Installation preparation

Unpack installation materials and accessories.
To improve allocation to the work steps, the packages are
identified differently.
To do this, comply with the overview sheet attached to the
appliance!
5.

Preparing the installation cavity

m
WARNING
Assure that there are no electrical wires or plumbing in
the area which the screws could penetrate.
Risk of injury and damage!
NOTE
– 2 anti-tip-angles are required for each appliance.
– The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
The anti-tip-angles must have a minimum length of 4
(105 mm) over the appliance to ensure a secure stand of the
appliance.
14
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening a spacer
behind the anti-tip angle, e. g. a sufficiently dimensioned
wood plank.
The length of the plank should correspond to the width of the
installation niche!

Specify the attachment points of the anti-tip-angles.
Specify the detailed dimensions according to the section
on "Installation dimensions" starting on page 9.

Attach the anti-tip-angles completely. Be sure screws
hold tight.
Fastening with wood screws
m
Fastening with dowels and screws
m
Always wear safety glasses and other necessary pro-
tective devices or apparel when installing or working
with anchors.
Risk of injury!
Not recommended for use in light-weight masonry material
such as block or brick.
Not recommended for use in new concrete which has not
had time to cure.
Do not use core drills to drill holes for this anchor.
1
/ "
8
CAUTION
m