W O L F
S T E A M E R M O D U L E
B E F O R E U S I N G F O R T H E F I R S T T I M E
Clean your steamer module thoroughly with
hot water and a mild detergent. Rinse and dry
with a soft cloth. This removes any residual oil
and grease left on the surface from the manu-
facturing process.
Refer to Care Recommendations on page 15.
Apply a stainless steel polish to protect the
finish and add luster.
During the initial period of use, you may smell
a light burning odor or see light smoke. Both
these conditions are normal with a new
cooktop module.
Water or liquid must be added to the
steamer basin before turning the unit on.
Serious injury or damage to the steamer
module may result when pouring liquid
into a heated steamer basin.
Do not use abrasive cleaners; they will
permanently scratch the surface.
10
S T E A M E R M O D U L E
O P E R AT I O N
U S E & C A R E
M O D E S
L O C K M O D E
In Lock mode, all touch pad operations on
the control panel are disabled and the heating
element is deenergized. A steady glowing light
in the
is locked. Refer to the illustration below for
location of the
To lock the control panel, touch and hold
the
will beep three times and the light in the
control unit is now in Lock mode.
To unlock the control panel, touch and hold
the
will beep twice and the light in the
touch pad will go out. The control unit is
now in Idle mode.
IMPORTANT NOTE: When the unit is powered
up for the first time or if there has been a
power outage, the steamer module will default
to Lock mode.
I D L E M O D E
After unlocking the control panel as described
in Lock Mode, the unit enters the Idle mode of
operation. The valid touch pad operations are
,
Lock mode
Temperature
Power indicator
LED display
bar graph
Lock "key"
DRAIN
touch pad
touch pad
Touch control panel
O F O P E R AT I O N
touch pad indicates that the unit
touch pad.
symbol for 3 seconds. The unit
touch pad will illuminate. The
symbol for 3 seconds. The unit
,
, "+" or "–" and the
.
Temperature
Timer LED
adjustment
OFF ON
touch pad
touch pad
display
CLEAR