Height Adjustment Of The Shoulder Belts; Using With The Carrycot; Assembling The Carrycot - Kiddy Evostar Light 1 Manual De Instrucciones

EN
seat from the bottom side. Mount the belt by pushing the clip from
the top side through the desired hole. Make sure that the clip lays flat
on the seat bottom side and the belt is not twisted. For children up to
a height of approx. 100 cm, anchor the end of the crotch belt in the
rear hole (fig. 22, b) is preferable.
The belt system is adjusted correctly when the belts lay firmly on the
child's body, not twisted and without pressure.

5.3 Height adjustment of the shoulder belts

Remove the back panel (fig. 14, no. 1).
Height adjustment by pushing the two buttons of the upper adjust-
ment option (fig. 23, no. 1) and simultaneous sliding between six po-
sitions (fig. 23, a–f).
To secure children from birth up to 6 months by the 5-point belt
system, adjust the shoulder belts in the lowest position (fig. 23, a) and
recline the backrest in lie-flat position (fig. 18, c).
Re-install the back panel (fig. 14, no. 2 + 3).

6. Using with the carrycot

6.1 Assembling the carrycot

Remove the apron and mattress to gain access to the stay bars in the
bottom of the carrycot. Using the tabs, pull the stay bars into the clips
on the baseboard until you hear them click into place (fig. 24). Repo-
sition the lining by closing the zippers (fig. 25) and place the mattress
back into the carrycot.
Important: Ensure that the stay bars are fully engaged before using
the carrycot.
12