Controls And Indicators - Virtus CUTTER 06 Manual Del Usuario

3.4.1 - Three phase 230 Volt-50 Hz machine
In this set-up, the machine is supplied with a power cable with section 4 x 1.5 mm.
This cable is connected to a three-phase three-pole plug+earth. Fasten the cable to
the three-phase power network with a magneto-thermal circuit-breaker (16 Amp).
3.4.2 - Single phase 230 Volt-50 Hz machine
In this set-up, the machine is supplied with a power cable with section 3 x 1.5 mm.
This cable is connected to a single-phase three-pole plug. Fasten the cable to the sin-
gle-phase power network (220V-50 Hz) with a magneto-thermal circuit-breaker (16
Amp).
For machine set-ups with different voltages, please consult the manufacturer,(in these
cases, the machine is supplied without a mains plug).
If you need to stretch the power cable, use a cable of the same section as the one in-
stalled by the manufacturer.
For instructions on how to check the proper electrical connection, see par. 5.1.

4 Controls and indicators

4.1 - List of controls and indicators
1 2
1 - Start button (continuous)
- Press the button to start the machine.
2 - Stop button
- Press the button to stop the machine.
3 - Speed control (optional for cutter 12 - 20)
Turn clockwise to increase the speed of the knives or counterclockwise to decrease it.
Fig. 4.1.1
3
Fig. 4.1.1
18
2.3 - Size and weight of the machine
CUTTER AxB CxD
mm mm
6 297x540 356x714 516x832
12 335x600 393x758 587x902
20 390x650 450x820 700x1013
Fig. 2.3.1
ExF G H L M Weight
mm mm mm mm mm
582 92 472 760
680 92 508 850
822 92 572 1010
11
kg
60
75
92