Technical Characteristics; Main Parts; Starting And Stopping The Machine; Technical Specifications - Virtus CUTTER 06 Manual Del Usuario

2 Technical characteristics

2.1 - Main parts

To facilitate understanding of the manual, the main components of the machine are
listed and shown in the Fig. 2.1.1 Main parts of the machine.
1. Electric motor;
2. Lid unlocking knob;
3. Tank;
4. Cutter (blades);
5. Lid;
6. Controls;
7. Tank gearbox;
8. PTO gearbox
(optional for cutter 12).
2

2.2 - Technical specifications

CUTTER Motor Ampere Motor
Blades Tank
Watt/Hp A Watt/Hp
6 370/0,5 1,8 /
370/0,5 1 /
12 750/1 3,5 90/0,12
750/1 2 90/0,12
20 2200/3 4,6 90/0,12
8 5
6
4
1
7
3
Fig. 2.1.1
Ampere Power Tank Capacity
A Volt/Hz mm Lt/Kg
/ 230/50 Ø430 h.71 6/4,5
/ 380/50 Ø430 h.71 6/4,5
0,88 230/50 Ø505 h.91,5 12/9
0,88 380/50 Ø505 h.91,5 12/9
0,88 380/50 Ø605 h.106,5 20/15
10

5 Starting and stopping the machine

5.1 - Checking the electrical connection
Switch the circuit breaker installed upstream of the machine to "I".
Press the start button ("1" Fig. 4.1.1), checking the direction of rotation of the tools
(380 three-phase version).
The blades must turn clockwise.
If the direction of rotation is counter-clockwise, disconnect the machine from the power
supply and contact the dealer nearest to you.
Note:
In machines connected to a single-phase line and configured for this type of power
supply, the correct direction of rotation is defined directly by the manufacturer.
5.2 - Checking for presence and efficiency of safety guards and devices
1 - Tool protective lid (Fig. 5.2.1)
Visually check for the presence and integ-
rity of the protective lid.
2- Microswitches (Fig. 5.2.1)
2a - with machine running, turn the lid lock
knob counter-clockwise: the machine must
stop.
2b - remove the tank and try starting the
cutter: the machine must not work.
If it does when performing this operation,
contact an authorised dealer or directly the
manufacturer.
IMPORTANT! In the case of absence, defects or incorrect adjustment of the casing,
or in case of incorrect functioning of the safety devices listed above, turn the machine
off and contact customer service to restore the machine to its original settings.

5.3 - Machine start-up

Turn the circuit breaker that supplies power to the machine from "0" to "1". Press start
button "1" (Fig. 4.1.1), thus activating tool rotation.
2a
1
2b
Fig. 5.2.1
19