Wall Hanging Instructions - Dimplex 6908760100 Manual Del Propietário

Fireplace Installation
hanging components are
designed for use with Dimplex
fireplaces only. Improper use,
or use for purposes other than
intended, may cause damage
or injury.

Wall Hanging Instructions

WARNING: Failure to install
the fireplace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
fire, serious injury, illness or
death.
WARNING: The fireplace
requires the wall hanging
bracket screws to be installed
into a minimum of one wall
studs (Figure 1).
Tools Required
• #2 Phillips screwdriver
• Pencil
• Slot screwdriver
• Bubble level (supplied)
• Drill, and drill bits as required
Approximate time: 30 minutes
for installation
1. Remove the two screws that
secure the hanging bracket
to the back of the firebox.
(Figure 1)
2. Select an appropriate location
8
to mount the unit on a wall,
above an electrical outlet.
Access to the electrical outlet
must be maintained. Ensure
the installation meets the
national and state/provincial
electrical codes.
!
NOTE: It is recommended
that the bottom of the unit
not be mounted higher than
1020mm (40") from the
Fireplace Installation ground
to maintain an optimized
viewing angle of the flame.
(Figure 2)
CAUTION: Ensure that the
top of the unit is at least
152mm (6") from the ceiling
or any object (i.e. Electrical
receptacles) that may
obstruct or be susceptible the
flow or temperature of air out
of the unit.
Figure 1
www.dimplex.com