Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Hints
and Care
How
to Remove
and
Replace
Light
Bulbs
/
]
_
[
/_-_!uJ/
How
to Get
the
WARNING
Most
Out
of
To avoid electrical shock which can cause severe personal injury or death,
\"r
S
disconnect
power to refrigerator before replacing light bulb. After replacing light
_
Your Energy
bulb, connect power.
Dollar
• When placing refrigerator into final
I
A
CAUTION
[
position, allow for 1" clearance
around the top and sides of unit to
To avoid personal injury or property damage, observe the following:
supply ample ventilation for
m
• Allow light bulb to cool.
optimum energy efficiency.
•
Wear gloves when replacing light bulb.
• Avoid overcrowding
refrigerator
shelves. This reduces effectivity of
...........
air circulation around food and
Upper refrigerator
section
causes refrigerator to run longer.
iiiiiiiiii
1. Locate finger gaps on each side of clear light
[_-_-_-_-'--]_
• Avoid adding too much warm food 'A
shield, insert fingers and press in on each side
_L___mJm
to unit at one time, This overloads
of shield. Pull shield down and remove,
compartments
and slows rate of
2. Remove light bulbs.
_
cooling.
3. Replace with appliance bulbs no greater
than
_
• Do not use aluminum foil, wax
40 watts.
_
paper, or paper toweling as shelf
liners. This decreases air flow and
4. Replace light bulb cover by inserting front tabs of
f_7
_ "l
_
causes unit to run less efficiently.
light shield into slots directly in front of light assembly.
............................................................................................................................................................................
• A freezer that is 2/3full runs most
efficiently,
1. Pinch bottom tabs (A) on light cover and pull straight
out.
2. Remove light bulb.
3. Replace bulb with appliance bulb no greater
than 40
watts.
4. Insert top tabs (B) of light cover into liner slots and
snap bottom portion over light assembly.
B
A
Freezer section
A
1. Remove ice bin by lifting front of bin and pulling out.
2. Remove light bulb cover by pinching top tab (A) and I/_
_'*
_1
pulling cover out.
l(_t_
_,'
!!f:_
_[
3. Remove light bulb. Replace with appliance bulb
l_
....
_'_
no greater than 40 watts
4, Insert bottom tab (B) of light cover into liner slots and snap
B
top portion over light assembly.
5, Replace ice bin by sliding in until bin locks into place.
Ice and Water dispenser ...........................................................
1
1. Locate light bulb inside top edge of dispenser frame. Unscrew
II
to remove.
_
_2.
Replace light bulb with a 6-watt, 120 volt bulb.
"/,,,_
Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances.
If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation.
Refer to this Use and Care Guide
section on temperature
controls for
recommended
control settings
Clean door gaskets every three
months according to this Use and
Care Guide's cleaning instructions.
This will assure that door seals
properly and unit runs efficiently.
Take time to organize items in
refrigerator to reduce time that door
is open.
Be sure your doors are closing
securely by leveling unit as
instructed in this Use and Care
Guide.
Clean condenser
coils as indicated
in the Use and Care Guide every 3
months, This will increase energy
efficiency and cooling performance.
15
Tabla de contenido
