Check The Presser Foot; Change The Presser Foot - Kenmore Sears 385. 19153 Manual De Instrucciones

• Check the presser foot
Your presser foot is held in place by a foot holder. Each presser foot merely snaps
on the foot holder, which is seldom removed,
if you need to remove or attach the foot holder, here is what you do:
To remove: To attach:
Presser
Turn the screw toward the back of the
machine. Use the large screw driver.
%............. J
!. Match the hole in the foot holder
with the threaded hole in the
presser bar.
2. Fit the foot holder screw into the
hole,
3. Tighten the screw by turnFngit
toward you,
The first step should be to make sure that the
sewing machine has been unplugged.
• Change the presser foot
Use the correct presser foot for the stitch you wish to sew. Consult the stitch pattern chart
and the detailed directions for sewing with the various presser feet,
To snap off:
_ pldown
needle
position
button
_Presser
I. Raise the presser foot.
2. Press the Up/down needle position button to raise the
needle to its highest position.
3, Unplug the machine,
4. Press the red button on the back of the foot holder.
The presser foot will drop off.
To snap on:
_ Pin
Groov!_
1, Set the pressure
adiusting lever at" 3"
2. Place the presser foot
so the horizontal pln on
the foot is lust under
the groove of the foot
holder.
3, Lower the presser foot
holder to lock the
presser foot in place.
24