Petsafe Drinkwell D360SS-CA-17 Manual De Funcionamiento página 8

8. Look into the Cone opening and make sure the Intake
Tube is sticking straight up from the Pump (fig. 7).
Carefully, insert the Filter Housing into the Cone
opening and push straight down (fig. 8). By pushing
the Filter Housing all the way down to the rubber
gasket, the Filter Housing should easily attach to the
Intake Tube.
9. Select one of the five interchangeable Spout Rings
based upon your personal preference or your pet's.
Place the chosen Spout Ring on top of Filter Housing
Cap and gently press down to secure in place (fig. 9).
fig. 8
10. On the Filter Housing Cap, align the Flow Control Cap with the raised notches
(fig. 10). Press down gently and the Flow Control Cap will snap into place. With
the Flow Control Cap, you will be able to easily adjust the intensity of the water flow.
Turn the Flow Control Cap to the right to increase the flow of water and turn to the
left to decrease. Important: If you notice a decrease in the flow of the water that
is not corrected by increasing the flow control to max flow, this may be an indication
of a clogged and dirty filter and/or the need to rinse and clean the Filter Housing.
Consult the "Filters and Pet Fountain Cleaning" section of this Operating Guide for
details on cleaning and maintaining your Pet Fountain.
1 1. Take one of the plastic Cord Clips and align with the electrical Power Cord hanging
over the rim of the Bowl. With the two-prong end on the outside of the Bowl
(fig. 11), slide the Cord Clip all the way down until it clips onto the bottom of the
Bowl (fig. 12).
12. Take the other two plastic Cord Clips and attach them to the Bowl so that the three clips
together form the three points of a triangle (fig. 13). This will lock the Cone in place.
8
.
fig. 11
www.petsafe.net
fig. 7 fig. 7
fig. 9 fig. 10
raised notches raised notches
fig. 12 fig. 13