Tv Operating Mode - Promax TV EXPLORER HD+ Manual De Instrucciones

USER'S MANUAL. TV EXPLORER HD+
Select the option by pressing the rotary knob and turn it to switch from OFF to ON.
Press the rotary knob to accept the change. Now there is a new option:
ASI OUTPUT SOURCE option as explained above, allows selecting the output
between two options: DEMODULATORS and AUXILIAR. The option DEMODULATORS
uses the TS that comes from the internal demodulator which is active at that time. The
AUXILIARY option uses any video file.
5.24

TV Operating Mode

When pressing the
HD+
TV EXPLORER accedes to the TV mode, and tries to demodulates on the monitor
the currently video signal on tune.
In the monitor will appear the TV picture with a window on the lower part to show,
for five seconds whenever the signal is analogue; the channel number, the frequency,
the active channel set, the colour system, the TV standard and the saturation level
(SYNC OK / SYNC FAIL).
If it is a digital television signal (DTV) on screen appears, for about some seconds,
the following parameters:
The top data box shows the tuned CHANNEL data: number or satellite name,
frequency, active channel plan and satellite downlink frequency.
The following data box shows the VIDEO data: type of video coding (MPEG-2 or
MPEG-4), video bit rate, profile and level with its resolution and aspect ratio, video
program identifier (VPID) and the TS identifier (TSID).
11/2013
[10] key from any mode of operation the
Figure 69.- Analogue channel monitoring.
Page 93