Installation; Power Supply; Operation Using The External Dc Charger; Operation Using The Battery - Promax TV EXPLORER HD+ Manual De Instrucciones

USER'S MANUAL. TV EXPLORER HD+

3 INSTALLATION

3.1

Power Supply

The TV EXPLORER
battery. There is also an external DC charger provided for mains connection and battery
charging.

3.1.1 Operation using the External DC Charger

Connect the
TV EXPLORER HD+ side panel. Connect the DC charger to the mains. Then, press the
rotary selector [1] for more than two seconds. The level meter is now in operation
and the battery is slowly charged. When the instrument is connected to the mains, the
CHARGER indicator [4] remains lit. This indicator changes of colour according to the
battery charge status:
RED
ORANGE
GREEN
Table 1.- Indication of the battery charge status (CHARGER).

3.1.2 Operation using the Battery

For the device to operate on the battery, disconnect the power cable and press the
rotary selector [1] for more than two seconds. The fully charged battery can power
the equipment for more than 4.5 hours non-stop.
If battery is very weak, the battery cut-off circuit will prevent the device from
functioning. In such a situation battery must be recharged immediately.
Before taking any measurements, you have to check the charge status of the
battery by checking the battery charge level indicator that appears when activating the
measurement mode pressing key
11/2013
HD+ is a portable instrument powered by one 7.2 V Li-Ion
external DC charger
BATTERY CHARGE STATUS
OFF
< 50 %
> 50 %
100 %
[12]. These are the indicators on screen:
to EXT. SUPPLY
ON
< 90 %
> 90 %
100 %
[32] on the
Page 13