Automatic Signal Identification Function (Auto Id) - Promax TV EXPLORER HD+ Manual De Instrucciones

USER'S MANUAL. TV EXPLORER HD+
Band
SATELLITE
TERRESTRIAL
MATV
(Master Antenna Television)
When the OUTPUT is enabled, the equipment puts at the output the voltage
selected by the user. When the OUTPUT is disabled it does not apply the voltage at the
output but it works like it was.
In the External power supply mode is the unit powering the amplifiers before the
antenna (terrestrial television) or the satellite TV receiver (house-hold or community)
also powers the external units.
The DRAIN [3] indicator lights when current is flowing to the external unit. If any
kind of problem occurs (e.g., a short circuit), an error message appears on the monitor
('SUPPLY SHORT'), the acoustic indicator will be heard and the instrument will cease to
supply power. The TV EXPLORER
until the problem has been solved, during this time it verifies every three seconds the
persistence of the problem warning with an acoustic signal.
5.8

Automatic signal identification function (AUTO ID)

The TV EXPLORER
the established configuration, which are presents in the channel or tuned frequency. In
order to activate this function must once press
combine this process with the spectrum monitoring
marker on the levels susceptible to contain a transmission, and activating later the
process of automatic identification in order to identify the present signal.
11/2013
Powering voltages
Output: Enabled / Disabled
External
5 V
13 V
15 V
18 V
24 V
13 V + 22 kHz
18 V + 22 kHz
Output: Enabled / Disabled
External
5 V
13 V
15 V
18 V
24 V
Table 3.- External units powering voltages.
HD+ does not return to its normal operating state
HD+ allows automatically identifying TV signals, according to
[25] key. Specially useful, is to
[13], so that after locating the
Page 33