Light Bulb Replacement; Fuse Replacement - Cushman 622023-ES Manual Del Propietário

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do
not touch new bulbs with bare fingers. Use clean, dry
tissue or paper towel to handle the glass portion of the
bulb.
For vehicles with headlights, locate the screws on back-
side of cowl that secure headlight. Remove screws, pull
headlight out and disconnect wires. Connect wires to
new headlight, install in cowl and secure with screws
5 previously removed.
To replace the turn signal light bulb, support turn signal housing from backside
of cowl while removing two screws securing lens. Install new bulb and replace
lens.
To replace the tail and brake light bulb, roll the rubber bezel from around the
edge of the taillight and remove lens. Install replacement bulb and replace
lens. To replace the tail and brake light bulb, remove hardware securing lens
and remove lens. Install replacement bulb.

FUSE REPLACEMENT

To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automo-
tive type fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or
the Service Parts Department.
5 - 8
Rear
Fender
Tail Light
Lens
Tail Light
Bulb
Screw
Headlight
Casing
Inside
of Cowl
Headlight
Bulb
Roll Rubber
Bezel Away
From Body
Tail/Brake
Light
Rear
Fender