To Fit The Nobark 10R - SportDOG NoBark 10R Manual De Funcionamiento

Task
Change active
operating mode
The light will fl ash every fi ve seconds to indicate the current mode.
_______________________________________________

To Fit the NoBark 10R

Important: The proper fi t and placement of your NoBark 10R is important for
effective operation. The contact points must have direct contact with your dog's skin
on the underside of his neck.
To assure a proper fi t, please follow these steps:
1. Make sure the NoBark 10R is off.
2. Start with your dog standing comfortably.
3. Place the NoBark 10R high on your dog's neck close to
the ears. Centre the contact points underneath your dog's
neck, touching the skin.
Note: It is sometimes necessary to trim the hair around the
contact points to make sure that contact is consistent.
4. Check the tightness of the NoBark 10R by inserting one
fi nger between the end of a contact point and your dog's neck. The fi t should be
snug but not constricting.
8
Push-Button Functions Continued
Steps to perform
1. Press the push-button
and hold it for at least 5
seconds.
2. Continue to hold the push-
button to advance to the
next available mode.
3. When the desired mode is
displayed, release the push-
button.
4. Once the push-button has
been released for 5 seconds,
the new operating mode
will go into effect.
5. If the push-button is
released too early, simply
press it again within 5
seconds.
www.sportdog.com/international
Indications
- Mode will advance and be
displayed as described on
page 6.
- Every 2 seconds the mode
will advance and be displayed.
- The selected mode will be
displayed during this time.
- The display will fl ash four times
and then the unit will resume
normal operation using the
new operating mode.
-The mode will advance and
continue as described in
Step 2.