Operational Cycles; Timed Positive Blast Chilling And Storage Cycle - eunasa 3GN 1/1 Manual De Instalación, Uso Y Mantenimiento

TIMED CHILLING
IF ON and the LED
on,
a
post
and storage cycle will have been selected.
SET TEMPERATURE CHILLING
IF ON and the LED
is also on, a post set-temperature chilling storage operation will be ongoing.
IF FLASHING, a set-temperature chilling and storage cycle will have been selected.
IF IT IS ON for ½ s every 3 s, the test to verify correct pin probe insertion will be ongoing.
IF FLASHING, and the LED
negative outcome (param.
IF FLASHING and the LED
continue
IF FLASHING, and the LEDs
device will have switched to storage mode and this will be ongoing
STORAGE
If is on, a storage operation will be ongoing. IF FLASHING, then the operational set-point will be being
modified while a storage operation is ongoing.
-d-
DEFROSTING OR DRIP DRAINING IS ONGOING
In the "ON" state, during normal operation, the display shows:
• The amount of time remaining for a timed blast chilling operation, if this is ongoing
• The temperature measured by the pin probe if a set-temperature chilling operation is ongoing
• The temperature of the cabinet, if storage is ongoing.
In "STAND-BY" mode, during normal operation, the display shows the temperature of the cabinet for ½ s
every 3 s.

2.5 OPERATIONAL CYCLES

The device has the following operational cycles:
• timed positive chilling and storage
• timed negative chilling and storage
• Set-temperature positive chilling and storage
• Set-temperature negative chilling and storage.
Set-temperature cycles are preceded by a test step in order to check correct insertion of the pin probe
(Paragraph 2.12)

2.6 TIMED POSITIVE BLAST CHILLING AND STORAGE CYCLE

To start the cycle:
- Ensure the device is in "stand-by" mode and no procedures are running
- Press to select "PoS" and ensure the LED
- Press within 15 s: the display will show the duration of the blast chilling step (in minutes)
- Press or
is selected, when the value assigned by parameter r1 is restored)
- Press within 15 s: the cycle will be activated.
is off, a timed chilling operation is ongoing. If ON and the LED
timed-chilling storage operation is ongoing. If Flashing, a timed
is off, a set-temperature chilling operation is ongoing. IF ON and the LED
is on, then the test to verify correct pin probe insertion will have had a
rc and rd) and the cycle will have been started in timed mode
is on, the chilling stage will have had a negative outcome, and so this will
and are on, the chilling stage will have had a negative outcome, the
within 15 s to change the value (the setting remains active until another cycle
is flashing
is also
chilling
23