Operation; Select Operating Mode; Setting The Rotation Direction; Switching On/Off - Parkside PABH 20-Li B2 Traducción Del Manual De Instrucciones Original

Operation

Select operating mode

■ Use the "Drill/hammer drill" switch
the operating mode of the power tool.
NOTE
► Change the mode only when power tool is
switched off. Otherwise, the tool could be
damaged.
♦ To change the operating mode, turn the "Drill/
hammer drill" switch
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF

Setting the rotation direction

NOTE
► Operate the rotation direction switch
when the appliance is at a standstill.
■ You can use the rotation direction switch
change the direction of rotation of the power
tool. This is not possible, however, while the on/
off switch is pressed in.
Clockwise:
♦ For drilling and screwing in screws, turn the
rotation direction switch
as the stop.
│ GB │ IE
■ 22
to select
to the desired position.
only
to
to the left as far
Anti-clockwise:
♦ For undoing and removing screws and nuts, turn
the rotation direction switch
far as the stop.
Switching on/off
Switching on:
♦ To start the power tool, press the on/off switch
and keep it pressed in.
■ The lamp lights up when the on/off switch
is pushed in slightly or fully and illuminates the
working area in low light conditions.
Switching off:
♦ To switch off the power tool, let go of the on/
off switch .
■ At low temperatures, the power tool will only
reach its full hammer performance/strike power
after a certain time.
■ To save energy, do not switch the power tool
on unless you plan to use it.

Set drill/hammer speed

■ You can infinitely adjust the drill/hammer speed
of the switched on power tool, depending on
how far the on/off switch
Pressing the on/off switch
low drill/hammer speed. Increasing pressure
increases the speed.
Run-on brake:
■ When you release the on/off switch
brake stops the chuck and prevents run-on of
the tool.
to the right as
is pressed in.
lightly yields a
, the
PABH 20-Li B2