Festo ELGA-TB-G Instrucciones De Utilizacion página 27

ELGA-TB-G, ELGA-TB-RF
• Attach the ELGA.
• Please select the corresponding accessories from our catalogue (
Foot mounting
HPE
Foot mounting on the mounting
( Fig. 2)
threads 1
caps
Tab. 1
• Tighten the mounting screws uniformly with the following tightening torque.
Size
HPE Screw
Tightening torque
MUE
Screw
Tightening torque
NST Screw
Tightening torque
Tab. 2
For installation in a vertical or inclined position:
Warning
Falling loads can cause personal injury and material
damage (crushing). If there is a power failure or the
toothed belt breaks, the work load will drop down.
• Make sure that you only use motors with an in-
tegrated spring-loaded holding brake.
• Check whether additional external safety meas-
ures against damage due to breaking of the
toothed belt are required (e.g. toothed latches,
moving bolts or emergency buffers).
Festo – ELGA-TB-G, ELGA-TB-RF – 1209a English
Profile mounting
MUE
Profile mounting in the slot of
the mounting surface 7
in the end
70
M5
[Nm] 5.9
M5
[Nm] 5
M5
[Nm] 5.9
www.festo.com/catalogue).
Slot nut mounting
NST
Slot nut mounting in the
groove aJ
80 120
M5 M8
5.9 24
M5 M8
5 20
M5 M8
5.9 24
Fig. 6
27