Locking The Safe - STACK-ON PFS-1608 Manual Del Proprietário

ENTERING YOUR SECURITY CODE (CONT.)
If the code fails, go to Step 1 and start again. If the code works successfully, then you
should lock the safe.
When you open the safe in the future, enter the security code you have set followed by the
green key and turn the knob.
If an incorrect security code is entered 3 times the safe will beep 5 times (if the sound is turned
on) and the red light will flash 5 times resulting in the safe being automatically locked out for 60
seconds before you can try your code again. The safe will beep one time (if the sound is turned
on) and the green light will flash once when the lockout period is over.
If an incorrect security code is entered 1 additional time the safe will beep 5 times (if the sound
is turned on) and the red light will flash 5 times resulting in the safe being automatically locked
out for 5 minutes before the code can be tried again. The safe will beep one time (if the sound is
turned on) and the green light will flash once when the lockout period is over.
Write your new combination on this form or store your combination on our secure website at
stack-on.com under Customer Service. If you write down your combination you must keep this
information in a secure place, away from children, not inside the safe.

LOCKING THE SAFE

12:00 POSITION
NOTE ON LOCKING THE SAFE:
Because the locking mechanism is deactivated for approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6 seconds from the time the combination is entered
to lock the safe. Also, when locking the safe, always make sure the knob is turned
completely to the left (counterclockwise) to the 12:00 position. If the knob is not turned to the
12:00 position during the locking process, the locking mechanism will not lock.
PFS-1608
®
PAGE 6 of 28
OWNER'S MANUAL
To lock the safe, close the door and turn the
knob counterclockwise to the 12:00 position.
40714-1609