Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ENG
1

CAUTIONS

Read the notes in this manual carefully. This manual contains important information on safe installation, use
and maintenance.
GENERAL WARNINGS
This device is only intended for the specifically designed use.
All other use is improper. The manufacturer cannot be held responsible for damage deriving from
improper, incorrect or unreasonable use.
The system must be built in compliance with the regulations in force. All devices in the system must be
exclusively used for the purpose for which they were designed.
Provide a suitable cut-off and protection master switch upstream from the devices, with contacts open
by at least 3 mm (0.12").
Make sure that the plate data corresponds to the power specifications before connecting the device to
the mains.
Check that the device is intact after removing it from the packaging.
Keep the packaging (plastic bags, polystyrene etc.) away from children. Packaging is potentially
dangerous.
Keep the ventilation or cooling openings and slots free.
Do not install the device in environments exposed to rain or humidity. Use specific boxes if required.
Disconnect the device from the mains by means of the system switch before cleaning or maintenance.
Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the device. Do
not tamper with the device.
Exclusively contact a service centre authorised by the manufacturer for repairs and in case of infiltration
of fluid or objects inside the device.
Do not use power extension wires.
Exclusively use the spare parts supplied by the manufacturer.
Installers must make sure that user's information is applied to the connected devices.
Disrespect of these precautions can affect safety of the device.
Keep this manual with the device at all times.
The information contained in this manual is subject to change without prior notice.
INSTALLATION PRECAUTIONS
This kit must be powered using the specific power supply included in the kit.
Position the components as shown on vertical, smooth supports respecting the instructions contained in
this manual.
Holding the electric lock opening button pressed could damage the lock.
CLEANING THE PARTS
Use a soft cloth to remove dust and dirt. Do not use aggressive detergent liquids (petrol, solvents etc.) which
could cause corrosion. Do not use spray products to clean the device.
2

OPERATION

This Video Door Phone System offers you complete control over the access of visitors to your
house. In addition, it allows you to identify the person who calls and provides convenient
operation to active the communication.
STAND-BY. No call to the Indoor Monitor. If the monitor does not receive a call, the functions
of electric lock
on the camera, the functions above become active.
RECEIVING A CALL. Indoor Monitor Activated and led 1 ON.
1. The ring-tone from the indoor monitor will be heard when a call is received from the outdoor
station. Following the screen will switch on and show the image of the person who has called.
If no other buttons are pressed the monitor will shut off after 60 seconds.
2. When the
button is pressed, communication is established with the person who is calling
and the led 1 is blinking. The conversation will end and the system is back to standby when
10
and supplementary service
are disabled. Press the
button to switch
DS1726-005
Tabla de contenido
loading

Tabla de contenido