Cautions; General Warnings; Installation Precautions; Cleaning The Parts - Urmet 956/94 Manual De Instalacion Y Uso

1

CAUTIONS

Read the notes in this manual carefully. This manual contains important information on safe installation, use
and maintenance.
1.1

GENERAL WARNINGS

•
This device is only intended for the specifically designed use.
•
All other use is improper. The manufacturer cannot be held responsible for damage deriving from
improper, incorrect or unreasonable use.
•
The system must be built in compliance with the regulations in force. All devices in the system must be
exclusively used for the purpose for which they were designed.
•
Provide a suitable cut-off and protection master switch upstream from the devices, with contacts open
by at least 3 mm (0.12").
•
Make sure that the plate data corresponds to the power specifications before connecting the device to
the mains.
•
Check that the device is intact after removing it from the packaging.
•
Keep the packaging (plastic bags, polystyrene etc.) away from children. Packaging is potentially
dangerous.
•
Keep the ventilation or cooling openings and slots free.
•
Do not install the device in environments exposed to rain or humidity. Use specific boxes if required.
•
Disconnect the device from the mains by means of the system switch before cleaning or maintenance.
•
Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the device. Do
not tamper with the device.
•
Exclusively contact a service centre authorised by the manufacturer for repairs and in case of infiltration
of fluid or objects inside the device.
•
Do not use power extension wires.
•
Exclusively use the spare parts supplied by the manufacturer.
•
Installers must make sure that user's information is applied to the connected devices.
•
Disrespect of these precautions can affect safety of the device.
•
Keep this manual with the device at all times.
•
The information contained in this manual is subject to change without prior notice.
1.2

INSTALLATION PRECAUTIONS

•
This kit must be powered using the specific power supply included in the kit.
•
Position the components as shown on vertical, smooth supports respecting the instructions contained
in this manual.
•
Holding the electric lock opening button pressed could damage the lock.
1.3

CLEANING THE PARTS

•
Use a soft cloth to remove dust and dirt.
•
Do not use aggressive detergent liquids (petrol, solvents etc.) which could cause corrosion.
•
Do not use spray products to clean the device.
DS956-021A 17