Cleaning The Cover, Shell And Pillows; Periodic Maintenance - CalSpas Fitness 2400 Manual Del Usuario

Cleaning and Maintenance
2. Remove the filter baskets and filters.
3. Drain your spa completely as described in the
instructions above.
4. Remove drain plugs from the front of the pumps.
5. Disconnect the unions from both sides of the pump.
6.
Use a wet/dry vacuum to blow any remaining water
out of the jets and equipment area.
Cover your spa with a good spa cover and an all-weather
tarp to ensure that neither rain nor snow enters the spa.
Cleaning the Cover, Shell and
Pillows
Due to the constant punishment your spa cover and
pillows receive, you should protect them by applying
Vinyl and Leather Cleaner as part of your monthly
maintenance plan. Cal Spas™ Vinyl and Leather
Cleaner is specifically designed to protect spa covers
and pillows from chemical and ultraviolet light damage. It
accomplishes this without leaving an oily residue behind
that is normally associated with common automotive
vinyl protectants.
Use of Vinyl and Leather Cleaner
Cal Spas™ Vinyl and Leather Cleaner should be used
sparingly. Incorrect usage may cause water clarity
issues.
Spa Covers
1. Remove spa cover from spa.
2. Allow spa cover to dry completely.
3. Spray Vinyl and Leather
Cleaner to cover evenly and
wipe dry.
4. Allow spa cover to dry
completely.
5. Reinstall cover on spa.
Pillows
1. Wipe pillows dry with a soft
cloth.
2. Carefully spray
Leather Cleaner directly onto
pillow.
3. Wipe pillows dry.
4. Allow pillows to dry completely.
Page 32
Vinyl and
Warning: Do not use automotive vinyl protectants on
spa covers or pillows. These products are generally oil-
based and will cause severe water clarity issues that are
difficult to correct.
All-Purpose Cleaner (Spa finish cleaning)
Cal Spas™ All-Purpose Cleaner is
an essential part of maintaining your
spa's finish. Through normal use, the
spa's finish can accumulate dirt, oil,
and calcium causing a rough feel and
unsightly scum lines. Cal Spas™ All-
Purpose Cleaner is a low detergent, non-
abrasive cleaner specifically formulated
to clean the spa without damaging its
acrylic finish.
The most effective solution to minimize cleaning time
is prevention. When the following steps are followed,
the spa's finish will actually start to resist most of the
elements that cause calcium build-up and make scum
line clean up easier.
Prior to Spa Start-Up and Refilling
1. Spray Cal Spas™ Multi-Purpose Cleaner directly on
to the spa's finish.
2. Wipe clean with a clean soft cloth.
3. Repeat on heavily calcified areas.
4. Wipe spa thoroughly with a wet sponge, rinsing
often with a bucket of clean water.
5. Allow spa to dry completely.
6. Apply a coat of Cal Spas™ Fast Sheen to the spa's
entire finish with a soft towel or sponge.
7. Allow Fast Sheen to dry until white and powdery.
8. Buff clean with a soft cloth, rotating frequently.

Periodic Maintenance

1. Spray Cal Spas™ Multi-Purpose Cleaner directly to
the spa's finish.
2. Wipe clean with a clean soft cloth.
3. Wipe spa thoroughly with a wet sponge, rinsing
often in a bucket of clean water.
Cal Spas™ Multi-Purpose Cleaner should not be
sprayed directly into the spa water. Incorrect usage of
this product will cause water clarity issues.
Fast Sheen (Spa finish protecting wax)
Cal Spas™ Fast Sheen is an essential part of maintaining
your spa's finish. Through normal use, the spa's finish
2009 Portable Spa Owner's Manual
LTR20091001, Rev. A