System Setting; Switches Setting - Urmet 956/94 Manual De Instalacion Y Uso

5.3

SYSTEM SETTING

USER A / USER B SELECTION
The two video entry phones included in the kit are set by default as User A and User B and are marked with
the respective letters on the transparent films that protect the display.
If you need to relink the video entry phone to the user or add a second video entry phone as slave, proceed
as follows:
- Press and hold the lock-release button
- The yellow LED
- The yellow LED
Configure alternately USER A or B to link them correctly to the 2 keys on the outdoor station, on which User
A always corresponds to the bottom key.
For the wiring diagram of a slave video entry phone wired in parallel with the master, see the bottom section
of this manual.
MASTER/SLAVE SELECTION ANDE LOCK-RELEASE TIMES
The back of the video entry phone features two selectors to configure the monitor as Master or Slave and
set the pedestrian lock time-out:
Master/Slave
MASTER
SLAVE
(Default)
The door opener time must be configured on the Master monitor.
IMPORTANT!
To enable configuration changes, you must disconnect and reconnect the power supply to the system. If the
green LED blinks when you switch on the system again, it means the system has detected a malfunction:
double check the configuration and connections.
APARTMENT SET-UP
1 VIDEO DOOR PHONE
2 VIDEO DOOR PHONE
22
will blink slowly for 30 seconds and will then switch off
will blink twice slowly for 30 seconds and will then switch off
Door opener contact
closing time: 3 sec
MASTER
for 5 seconds
Pedestrian door opening time
Door opener contact
closing time: 4 sec
MASTER
SLAVE
USER A
USER B
Door opener contact
closing time: 300 ms
(Default)
DS956-021A